General Warnings; Replacement Parts - Binks MX1231 Manual De Servicio

HIGH PRESSURE CAN CAUSE SERIOUS INJURY IF EQUIPMENT IS INSTALLED OR USED INCORRECTLY—
READ, UNDERSTAND, AND OBSERVE ALL WARNINGS AND INSTRUCTIONS IN THIS MANUAL.
INSTALL, OPERATE OR SERVICE THIS EQUIPMENT ONLY AFTER
It is the responsibility of the employer to place this information into the hands of the operator.
WARNING
!
Hazards or unsafe practices which could
result in severe personal injury, death or
substantial property damage.
AVOID STATIC SPARKING
1. Use Binks NO-WIRE conductive hose
in all airless spraying operations. Be
sure the gun and hose have continuity.
2. Make sure the pump is grounded.
NEVER operate the unit when it is on
a non-grounded platform.
3. When flushing or cleaning with a
combustible solvent, always use an
open metallic container for receiving
the waste solvent. Ground the solvent
receptacle.
4. ALWAYS remove spray tip when
flushing the system. Operate the pump
at the lowest possible pressure.
Conductive Hose
To Airless Pump
Bonding Wire,
Gun To Solvent Container
77-2919-R6.3 (8/2015)
WARNING
!
ALL INSTRUCTIONS ARE CLEARLY UNDERSTOOD.
!
Hazards or unsafe practices which could
result in minor personal injury, product
or property damage.

GENERAL WARNINGS

1. NEVER leave a pressurized sprayer
unattended.
2. Periodically inspect all hoses for leaks
and/or abrasions and tighten all
connections before use. DO NOT
ATTEMPT TO REPAIR a defective
hose. REPLACE it with another
conductive hose.
3. ALWAYS relieve pressure in the
system by turning bypass valve to
BYPASS or triggering spray gun
before disassembly of any component
parts.
Never store de-ionized, distilled, reverse
osmosis or any pure grade of water in the
Open
pump. These fluids may cause corrosion.
Metallic
Waste Solvent
Container,
Grounded
BINKS is not responsible for misapplica-
tion of pumps. Consult your BINKS repre-
sentative for application assistance.
CAUTION
CAUTION
NOTE
3 / 12
NOTE
Important installation, operation or
maintenance information.
NOTE
Be sure that all fluids, solvents and
fillers to be used are chemically and
physically compatible with wetted
parts in the pump. Consult your BINKS
representative for pump materials of
constructions and compatibility infor-
mation. Consult the fluid manufacture
for information regarding the fluids to
be used.

REPLACEMENT PARTS

The pump is designed to use authorized
parts only. When using this pump with
parts that do not comply with the
minimum specifications and safety
devices of Binks, the user assumes all
risks and liabilities.
WARNING
!
EXCESSIVE AIR PRESSURE
Can cause personal injury, pump dam-
age or property damage. Do not exceed
maximum inlet air pressure as stated on
motor model plate.
EN