How To Use; Getting Started - Black and Decker HGS310 Manual Del Usario

HOW TO U S E
This product is for household use only.
G E T T I NG STARTE D
• Remove all labels, tags and stickers attached to the body, or cord of the
steamer and the plastic band around the power plug.
• Remove and save literature.
• Read all the instructions before using your steamer.
IM P O RTAN T NOTE S
• Using distilled, purified, or filtered water is highly recommended to
maintain optimal performance. Tap water contains minerals that build up
over time.
• Any water droplets visible inside the tank are from individual quality
control tests done to ensure every steamer meets our high standards for
product performance.
• Do not use perfumes, oils, or other additives.
• Always review the garment manufacturer's care label instructions before
steaming, and always test fabrics for colorfastness in inconspicuous
areas (such as an inseam). Steamers are not recommended for use on
leather, suede, vinyl, plastic, or other steam sensitive fabrics.
• During use the steamer and accessories will become hot. Avoid
attaching or removing frames while still hot.
• After preheating, prime water pump by holding the steam trigger until
steam forms.
• It is normal to feel or hear the water pump in the handle.
• The water pump may become louder when the water level in the tank is
low. Check and refill tank, as needed.
SETTING UP THE IRONING PAD
1. Select a door close to an outlet and handy for quick
touch-ups, such as a closet or laundry room door.
Note: The pad includes a heat protection backing to avoid
damage to doors; however, some condensation can build
up during extended use. Always check the door and wipe
off any condensation after use.
2. Secure the door to stabilize it during set-up.
3. Adjust straps to create large loops to fit over door corners.
4. Slip one of the strap loops over the corner of the door
(A) with the pad facing front, then hang other strap.
(B) Gently tug on the pad to make sure it's secure.
4
A
B