Setting; Draining The Oil - OFFCAR S.700 U7FRE-13 Manual De Instrucciones, Uso Y El Mantenimento

2.2 SETTING

Fig.4
B
A
START-UP
- Use the main switch to switch on the appliance.
- Turn knob A to position "1" (fig.3).
- Turn knob B to set temperature.
- AVOID OVERHEATING OIL
When the green light comes on, the appliance is ready for use. The transparent light remain lighted whilst the heating
elements are heating up the oil. As soon as the oil reaches the set temperature the heating elements switch off and the
transparent light goes out.
When the temperature falls below the set level the heating elements come on again automatically.
SWITCH-OFF
- Turn knob B to position "0".
- Turn knob A to position "0".
- If the appliance is not used, switch off the circuit breaker.
- Place the lid on the frying compartment/frying compartments.
WARNING:
Old oil catches fire at a lower temperature and makes froth that tends to boil over. Remember that placing food that is too
moist and placing too much food in the fryers contributes to the formation of froth that may boil over.

DRAINING THE OIL

In order to drain the basin of the used oil, allow the oil to cool, open the fryer's door, fit the oil collection basin with the
relevant filter, if it has not already been inserted, and open the drain cock. The oil will come out from the tap and the tank
empties. To keep the oil at its best, it is advisable to leave it in a cool place once it has been filtered.
Pag. 8