Faber TRATTO IS 36 Instrucciones De Instalación Información De Uso Y Cuidado página 12

Remove the cover from the field wiring compartment. (SEE
FIGURE 11) DO NOT turn on the power until installation is
23
complete! Connect the Power Supply Cable to the rangehood.
8
Connect the Green (Green and Yellow) ground wire under the
Green grounding screw. Attach the White lead of the power
supply to the White lead of the rangehood with a twist-on type
7.1a wire connector. Attach the Black lead of the power supply
to the Black lead of the rangehood with a twist-on type wire
connector.
7.1b
2.1
A. Home power supply cable
B. Black wires
C. UL listed wire connectors
A. Home power supply cable
2.2
D.White wires
B. Black wires
E. Green (or bare) ground wire from home power supply
C. UL listed wire connectors
connected to green ground screw
D. White wires
F. Range hood power supply cable
E. Green (or bare) ground wire from home power supply connected to green ground screw
G.Range hood power supply cable connected to green
F. Range hood power supply cable
ground screw
G. Range hood power supply cable connected to green ground screw
9
Ductless installations require
a Ductless Conversion
Kit whose components are
12f
pictured in FIGURE 12. Do
not use the DAMPER (M
in FIGURE 1) for ductless
installations. The LOWER
C H I M N E Y C O V E R ( B
in FIGURE 1) should be
discarded and replaced by
the new one with holes from
the Ductless Conversion Kit
(D in FIGURE 12).
As indicated in FIGURE
12
12, place the DUCTLESS
11
12h
9.1
9
25
12e
24
FIGURE 11
12c
FOR DUCTLESS INSTALLATIONS
Position the upper chimney section and fix the upper
part to the frame using the 2 screws removed previously.
1. The UPPER CHIMN
COVER (C in FIGURE
Installation of wiring
attaches to the top of
connection
support structure using
Remove the cover from the
screws provided (G in FIGU
field wiring compartment.
13). If using the High Cei
DO NOT turn on the power until
Chimney Kit, use the UPP
installation is complete!
CHIMNEY COVER supp
Connect the Power Supply
with the kit. Slide up
Cable to the rangehood.
attach the UPPER CHIMN
Connect the Green (Green and
COVER.
Yellow) ground wire under the
Green grounding screw. Attach
2. Attach the duct work to
the White lead of the power
DAMPER (M in FIGURE
supply to the White lead of the
Make sure to seal all joints
rangehood with a twist-on type
duct tape to prevent leaks
wire connector.
Attach the Black lead of the
3. The LOWER CHIMN
power supply to the Black lead
COVER (B in FIGURE
of the rangehood with a twist-
attaches using two scr
on type wire connector.
provided (G in FIGURE
Install the LOWER CHIMN
Replace the field wiring compart-
COVER by sliding it up o
ment cover and the grease filters.
the support and the UPP
CHIMNEY COVER.
For ductless installations
EXTENSIONS HORIZON
in the LOWER CHIMNEY
in the VENT GRIDS (C i