Chauvet DJ NIMBUS Jr Guía De Referencia Rápida página 2

Nimbus™ Jr. QRG
About This
Guide
Disclaimer
Safety Notes
Contact
The Nimbus™ Jr. Quick Reference Guide (QRG) contains the product's
connection, mounting, and operation information. Download the User
Manual from www.chauvetlighting.com
The information and specifications contained in this QRG are subject to
change without notice.
These Safety Notes include important information about installation, use, and
maintenance, including DRY ICE WARNINGS. Read carefully!
· This product is not intended for permanent installation. Mounting in any
form is not recommended. Operate the product while on the ground.
· Do not set this product on a flammable surface (linoleum, carpet, wood,
paper, carton, plastic, etc.).
· This product's nozzle is very hot during operation and remains hot for a
long time after use. Do not touch the nozzle during or after operation
(until cooled).
· The fog exits the nozzle at a very high temperature. Keep a minimum
distance of 6.5 ft (2 m) from the nozzle to the nearest object.
· DO NOT cover or plug the output nozzle during operation. Compressing
the dry ice will cause a chemical reaction that may lead to an explosion.
· Do not handle dry ice with bare hands. Thick gloves must be worn.
· Do not swallow dry ice. It will lead to severe internal injuries.
· Before breaking dry ice, cover it with a piece of cloth or place the block in
a cloth bag. Eye protection must be worn.
· During warm-up and operation, the water in the Nimbus™ Jr. will be
extremely hot. Do not touch or allow the water to splash to avoid scalds.
· Do not remove the basket while the product is connected to power.
· Do not use in a room less than 10 sq ft (1 m
enclosed room is well ventilated.
· Dry ice should never be stored in a sealed container that can lead to a
pressure build-up and the risk of an explosion.
· Do not continue to create fog once visibility is 20 inches (50 cm) or less.
· Condensation may form on the bottom of the product, creating damp or wet
conditions under and around the Nimbus™ Jr. Use caution! Surfaces
around the product may become slippery.
· The voltage of the outlet to which you are connecting this product must be
within the range stated on the decal or rear panel of the product.
· ONLY connect this product to a grounded and protected circuit.
· Make sure the power cord is not crimped or damaged.
· Never disconnect this product from power by pulling on the cord.
· In the event of a serious operating problem, stop using immediately.
· Not for space heating purposes.
Outside the U.S., United Kingdom, or Ireland, contact your distributor to
request support or return a product. Visit
contact information.
for more details.
2
2
) and make sure that any
www.chauvetlighting.com
EN
for