Environmental Protection - Worx Sonicrafter WX681 Manual Original

We recommend that you purchase your
accessories listed in the above list from the
same store that sold you the tool. Use good
quality accessories marked with a well-known
brand name. Refer to the accessory packaging
for further details. Store personnel can assist
you and offer advice.
NOTE: When plunging and sawing use a slight
pendulum motion, to allow sufficient chip
removal.
The saw blade lasts longer if the wear
is distributed evenly. To ensure an even
distribution, loosen the saw blade, rotate it
and retighten firmly.
Cut/Sand with a constant movement and light
pressure.
Heavy pressure does not increase the cut/
removal rate – the accessory merely wears
faster.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
Oscillating Tool
PLUG REPLACEMENT
(UK & IRELAND ONLY)
If you need to replace the fitted plug then
followthe instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
blue – neutral
brown – live
As the colors of the wires in the mains lead
of thisappliance may not correspond with the
coloured markings identifying the terminals
in your plug,proceed as follows. The wire
which is coloured blue must be connected to
the terminal which is marked with N. The wire
which is coloured brown must be connected to
the terminal which is marked with L.
WARNING: Never connect live or
neutral wires to the earth terminal of the
plug. Only fit an approved 13A BS1363/A
plug and the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
EN
11