Long press the button 8 to jump back to the start of the music playlist.
Press briefly 9 to skip to the next track.
Long press the button 9 to raise the playback volume.
4. AUX IN mode
Connect the speaker to an audio source (PC, MP3/MP4, mobile phone) via 3.5mm audio cable. Short press 3
to enter "AUX IN" mode (speaker indicates "AUX IN"). Music begins to play from the audio source.
Notes:
•
If you are connecting the speaker to a computer with a 3.5 mm audio cable, we recommend using
a genuine adapter (5 V / 2 A) to charge the speaker instead of the computer USB port. Powering the device
from the computer may be insufficient.
•
Short press 8 to lower the music volume. The source of music continues to play the music at a lower
volume.
5. FM tuner
Short press 3 to initiate FM mode (the speaker indicates "Mode FM"). Short press 7 / 8 to tune to previous/
GB
next station. Long press the buttons 7 / 9 to adjust the playback volume.
6. Card reader
Insert your Micro SD card into the speaker and switch OFF. Connect the speaker to the computer via USB cable.
After the speaker switches to memory card mode, files can be read and written to the computer from the Micro
SD card.
Note: The necessary computer driver is installed when using this feature for the first time.
7. Intelligent energy-saving feature
The speaker will turn off automatically if you pause playback or pause the Bluetooth connection for more than
10 minutes in playback mode.
Note: Long press 1 again to switch the speaker ON again.
8. Power bank
When the speaker is off, press the button 5 the battery indicator starts flashing. Use the USB cable to connect
the mobile phone/MP3 player/tablet, etc. to the speaker, the speaker starts charging the device as a power
bank.
9. Charging
If the speaker battery is nearly empty, the speaker will report it with the message "out of battery" (empty
battery). Charge the battery using the USB adapter. During charging, the orange LED indicator lights up. When
the charging is finished that orange indicator turns off.
Notes:
•
Only use a quality adapter to charge the speaker.
•
We recommend using an adapter with the following parameters: 5 V / 2 A, full charge takes about 4 hours.
•
Always charge the speaker immediately after the speaker indicates the battery is empty.
•
The speaker can also be charged with a lower charging current. The charging cycle can take a very long
time when the battery is charged via standard USB port with a current of 500 mA.
32