Rear Panel - Work Pro PA 90/2 USB Manual De Uso

REAR PANEL

16
10
(10) AC JACK
This connector is meant for connection of the supplied main cord. Do not insert the power
cord into this unit until voltage has been correctly set.
(11) GND
It is ground connection
(12) DC INPUT
It is used for DC power supply for 12V. You should pay attention to the polarity.
(13) OUTPUT TERMINALS
Low impedance output is 4? , constant voltage output is 25V, 70V, 100V.
(14) PRE OUT/AMP IN
Jacks AMP IN and PRE OUT to insert an audio unit for signal processing.
(15) AUX INPUT
It allows to connect an audio source with a high level output signal, such AM/FM tuner,
CD player, etc.
(16) MAIN VOLTAGE SELECTOR
There are two voltages to choose: 115V /230V. Check the local voltage before connecting
the unit.
11 12 13
PA 90/2 USB
14 15
User Manual/Manual de Uso
EN
Pag. 4