Care And Cleaning; Troubleshooting - Home Decorators Collection HDI-4017-BK Guía De Uso Y Cuidado

Installation (continued)
4
Mounting the light fixture base
□
Push the wires into the juction box.
□
Slide the light fixture (A) onto the large
mounting screws (DD) and tighten the
decorative fixture nuts (CC) against the light (A).
□
Caulk around the fixture base with silicone
weather sealant after all testing and
adjustments are complete.
5
Installing the light bulb
□
Install the bulb (tungsten incandescent,
medium base, type "A", 60 watt maximum -
not included) into the light fixture (A).

Care and Cleaning

□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.

Troubleshooting

Problem
The light will not come on.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit
breaker is turned off.
□
Light bulb is loose or burned out.
□
The circuit wiring is incorrect (if this
is a new installation).
CC
A
A
Solution
□
□
□
□
6
DD
Turn the light switch on.
Replace the fuse or turn the
circuit breaker on.
Check bulb and replace if
burned out.
Verify the wiring is correct.