Mi-T-M Corporation GEN-1100-0MS0 Manual Del Operador página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of injury, read this operator's
manual completely before using. When using this
product, the following basic precautions should always
be followed:
. Read all the instructions before using the product.
2. Do not enclose the generator nor cover it with a box. The
generator has a built-in forced air cooling system, and may
become overheated if it is enclosed. If generator has been
covered to protect if from the weather during non use,
be sure to remove it and keep it well away from the area
during generator use.
3. Operate the generator on a level surface. It is not
necessary to prepare a special foundation for the generator.
However, the generator will vibrate on an irregular surface,
so choose a level place without surface irregularities.
If the generator is tilted or moved during operation, fuel
may spill and/or the generator may tip over, causing a
hazardous situation.
Proper lubrication cannot be expected if the generator is
operated on a steep incline or slope. In such a case, piston
seizure may occur even if the oil is above the upper level.
4. Pay attention to the wiring or extension cords from the
generator to the connected device. If the wire is under
the generator or in contact with a vibrating part, it may
break and possibly cause a fire, generator burnout, or
electric shock hazard. Replace damaged or worn cords
immediately.
5. Do not operate in rain, in wet or damp conditions, or with
wet hands. The operator may suffer severe electric shock if
the generator is wet due to rain or snow.
6. If wet, wipe and dry it well before starting. Do not pour
water directly over the generator, nor wash it with water.
7. Be extremely careful that all necessary electrical grounding
procedures are followed during each and every use. Failure
to do so can be fatal.
8. NEVER try to power the house wiring by plugging the
generator into a wall outlet, a practice known as "back
feeding". This is an extremely dangerous practice that
presents an electrocution risk to utility workers and
neighbors served by the same utility transformer. It also
bypasses some of the built-in household circuit protection
devices.
If you must connect the generator to the house wiring to
power appliances, have a qualified electrician install the
appropriate equipment in accordance with local electrical
codes. Or, check with your utility company to see if it can
install an appropriate power transfer switch.
9. No smoking while charging a battery. The battery emits
flammable hydrogen gas, which can explode if exposed to
electric arcing or open flame. Keep the area well-ventilated
and keep open flames / sparks away when charging a
battery.
Operator's Manual
3

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido