Mi-T-M Corporation GEN-1100-0MS0 Manual Del Operador página 28

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
WATTAGE INFORMATION:
Some appliances need a "surge" of energy when starting. This means
that the amount of electrical power needed to start the appliance may
exceed the amount needed to maintain its use.
Electrical appliances and tools normally come with a label indicating
voltage, cycles / Hz, amperage (amps) and electrical power needed to
run the appliance or tool.
Check with your nearest dealer or service center with questions
regarding power surge of certain appliances or power tools.
• Electrical loads such as incandescent lamps and hot plates require
the same wattage to start as is needed to maintain use.
• Loads such as fluorescent lamps require 1.2 to 2 times the indicated
wattage during start-up.
• Loads for mercury lamps require 2 to 3 times the indicated wattage
during start-up.
• Electrical motors require a large starting current. Power requirements
depend on the type of motor and its use. Once enough "surge" is
attained to start the motor, the appliance will require only 30% to 50%
of the wattage to continue running.
• Most electrical tools require .2 to 3 times their wattage for running
under load during use.
• Loads such as submersible pumps and air compressors require a
very large force to start. They need 3 to 5 times the normal running
wattage in order to start.
NOTE: The following wattage chart is general guide only. Refer to your
specific appliance for correct wattage.
To determine the total wattage required to run a particular electrical
appliance or tool, multiply the voltage figure of the appliance / tool by
the amperage (amps) figure of same. The voltage and amperage (amps)
information can be found on a name plate which is normally attached
to electrical appliances and tools.
CAUTION: IF AN ELECTRIC MOTOR FAILS TO START OR
REACH RUNNING SPEED, TURN OFF THE
APPLIANCE OR TOOL IMMEDIATELY TO AVOID
EqUIPMENT DAMAGE. ALWAYS CHECK THE
REqUIREMENTS OF THE TOOL OR APPLIANCE
BEING USED COMPARED TO THE RATED OUTPUT
OF THE GENERATOR.
Applications
Incandescent Lamp, Heater
Fluorescent Lamp, Electric Tool
Mercury Lamp
Compressor Pump
28
Operating the Generator
Applicable Wattage (W)
60 Hz
approx. 900
approx. 450
approx. 250
approx. 200
Operator's Manual

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido