Hotpoint Ariston FK 89P X /HA S Manual De Instrucciones página 26

Ocultar thumbs Ver también para FK 89P X /HA S:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

• The inside of the oven should ideally be cleaned after
GB
each use, while it is still lukewarm. Use hot water and
detergent, then rinse well and dry with a soft cloth. Do
not use abrasive products.
• All accessories - with the exception of the sliding racks
- can be washed like everyday crockery, and are even
dishwasher safe.
• We recommend that detergents are not sprayed directly
onto the control panel, but that a sponge is used instead.
! Never use steam cleaners or pressure cleaners on the
appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with a
soft cloth. Do not use rough abrasive material or sharp metal
scrapers as these could scratch the surface and cause the
glass to crack. For more thorough cleaning purposes, the
oven door may be removed:
1. Open the oven door fully (see diagram).
2. Use a screwdriver to lift up and turn the small levers F
located on the two hinges (see diagram).
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.
Replacing the light bulb
Lamp
Holder
compartment
Lamp
Glass cover
26
F
3. Grip the door on the two outer
sides and close it approximately
half way. Pull the door towards you,
lifting it out of its slot (see diagram).
To replace the door, reverse this
sequence.
To replace the oven light
bulb:
1. Remove the glass cover
of the lamp-holder.
2. Remove the light bulb and
replace it with a similar one:
halogen lamp voltage 230 V,
wattage 25 W, cap G 9.
3. Replace the glass cover
(see diagram).
! Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.
Automatic cleaning with the FAST CLEAN
function
With the FAST CLEAN mode, the internal temperature of
the oven reaches 500°C. The pyrolytic cycle is activated,
burning away food and grime residues. Dirt is literally
incinerated.
Keep children away from the appliance during the automatic
cleaning cycle as surfaces may become very hot. Particles
may ignite inside the oven due to the combustion process.
There is no cause for concern: this process is both normal
and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the inside of
the oven using a damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where
present);
• Do not place tea towels or pot holders over the oven
handle.
• Turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not start. Wait
for the oven to cool down.
! The programme may only be started once the oven door
has been closed.
To activate the FAST CLEAN cycle press and hold the
button for approximately 4 seconds. The TIMER KNOB may
be used to select the desired cleaning level; there are three
default time settings which cannot be modified.
1. Economy (ECO): turn the knob towards " ". Duration 1
hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards " ". Duration 2
hours.
4. Press the
button to confirm.
An end time for the FAST CLEAN cycle (as for a normal
cooking cycle) may be programmed (see Programming the
automatic cleaning end time).
Safety devices
• The
icon on the display, when lit, indicates that
the oven door was automatically locked as soon as the
temperature reached a high value.
• The
icon indicates that the cleaning cycle may
be cancelled at any time by pressing the
• If a malfunction occurs, the heating elements will be
switched off.
button.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fk 89p /ha sUt 89 p x /ha sUt 89 p /ha s

Tabla de contenido