Nightlight; Lullabies, Nightlight, Talk-Back And Vox Setting In Eco-Mode; Temperature Tracking - TIGEX Easy Protect Plus Instrucciones De Uso

3. Switch the function off by briefly pressing the Lullabies
on/off button 10.
The lullabies icon 28 disappears and the lullabies will
stop playing.
Caution!
– The five noise level indicators 2 are switched off
while lullabies are playing, because the device
cannot distinguish between a baby crying and a
lullaby being played, but you will still be able to hear
if your baby is crying in the background. Therefor in
case the parent unit was muted previously an
activation of the lullabies will automatically turn back
to volume level 1.
– We always recommend that you do not use the mute
setting on the parent unit while lullabies are being
played, because this would leave you with no
monitoring functions at all and quite unable to hear if
your baby cries.

9.5 Nightlight

The nightlight function provides for a soft dim light in the
nursery and helps the baby with a little orientation in the
dark.
1. Activate the function by briefly pressing the Nightlight
on/off button 11.
The nightlight 16 switches on. The display 4 shows the
nightlight icon 26.
2. Switch the nightlight off by briefly pressing the
Nightlight on/off button 11 again.
The nightlight 16 switches off. The nightlight icon 26
disappears.
Note: The Nightlight will stay on until you switch it off
manually.
9.6 Lullabies, Nightlight, Talk-Back and VOX
Setting in Eco-Mode
While you baby is sleeping the baby unit is also "sleeping"
and the Eco-Mode is activated. During the activated Eco-
Mode the special features such as the lullabies, the
nightlight or the talk-back function are deactivated and can
not be changed.
This is a safety setting to avoid that you may wake your
baby by accident.
In case you want to change the setting of the special
functions follow the stepps explained above. The adequate
icon will start blinking on the display to indicate that the
Eco-Mode is still active. The setting change will be
transmitted with the next link check, which can take up to
30 sec (see "5.2 Special Features during activated Eco-
Mode" on page 53).
Note: If you activate the lullabies or use the Talk-Back
function you may not only wake up your baby, you also
deactivate the Eco-Mode.

9.7 Temperature tracking

The correct nursery temperature is particularly important
for baby's healthful sleep. The baby unit of this baby
monitor has an integrated temperature sensor. The
temperature in the nursery is always shown on the display
4 and is updated automatically.
The baby unit checks the nursery temperature and sends
warnings to the parent unit (see "8. Alerts, warnings and
indicators" on page 56). The following signals are displayed
on the display 4 of the parent unit 1:
LO (flashing):
The temperature has fallen below the lower threshold of
10 °C.
The nursery temperature has reached an extremely
critical level and urgent action is required to increase
the temperature in the nursery.
10 °C to 15 °C (flashing):
This temperature is too low for baby to sleep properly.
Check the heating and adjust it if necessary.
15 °C to 30 °C:
This temperature is suitable for baby to sleep properly.
30 °C to 35 °C (flashing):
This temperature is too high for baby to sleep properly.
Check the ventilation or air conditioning and adjust it if
necessary.
HI (flashing):
The temperature has risen above the upper threshold of
35 °C.
The nursery temperature has reached an extremely
critical level and urgent action is required to reduce the
temperature in the nursery.
Note: Since the temperature sensor is inside the baby unit
it is important that you do not cover it or place it near any
heat source or on any cold surface. Direct sunlight may
also affect the reading.
58