Optional Accessories - Makita XSS01 Manual De Instrucciones

011500
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver with a slender shaft or the like.
1
2
011501
Use pliers to remove the carbon brush caps of the carbon
brushes. Take out the worn carbon brushes, insert the
new ones and replace the carbon brush caps in reverse.
1
011502
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
1
2
006304
Reinstall the rear cover and tighten two screws securely.
After replacing brushes, insert the battery cartridge into
the tool and break in brushes by running the tool with no
load for about 1 minute. Then check the tool while
running and electric brake operation when releasing the
switch trigger. If the electric brake is not working well, ask
your local Makita service center for repair.
1. Rear cover
1
2. Screw
2
1. Recessed part
2. Spring
3. Arm
3
1. Carbon brush
cap
1. Hole
2. Carbon brush
cap
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use the accessories or
attachments for their stated purposes.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Drill bits
•
Tungsten-carbide tipped hammer bit
•
Phillips bit
•
Slotted bit
•
Socket bit
•
Blow-out bulb
•
Safety goggles
•
Various type of Makita genuine batteries and
•
chargers
Hook
•
Bit holder
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
9
or attachments are