MTD OEM-190-182A Manual Del Operador página 13

3. Install the bagger screen into the bagger cover by first inserting
the end closest to the side with the cutout into the
mounting hole, as in Fig. 4-13. Make sure to feed the screen
under the lip, as in Fig. 4-14.
Figure 4-13
4. Clip in the other side by pushing the screen into the provided
cutout. See Fig. 4-14.
Make sure screen sits
under the cover's lip
Figure 4-14
5. Install the bagger cover onto the bag support assembly, as
seen in Fig. 4-15. The plastic cover goes inside of the two
mounting tabs.
6. Slide the hinge pin into the hole located on the mounting tab, as
in Fig. 4-16. Use the cut-out window (See inset in Fig. 4-16)
to line up the hinge pin on the other side and push pin all
the way in until it reaches the end-stop. At this point the
pin clips into place and is secured by a tab in the bagger
cover. See Fig. 4-17.
Figure 4-15
Figure 4-16
Figure 4-17
s 4 — a & i
ectiOn sseMbly nstallatiOn
13