Helpful Hints - Ambiano CM9405T-UL Manual Del Usuario

6. When the delayed brew time begins, the ON/OFF indicator light will illuminate
to RED.
7. You may see the delay brew time by pressing DELAY BREW.
8. Cancel DELAY BREW by pressing ON/OFF.
9. If you want to change the delay brew time, follow steps 2 through 4 above.
10. The brewing process may be interrupted 2 ways;
a. Pressing the ON/OFF button (must press again to continue brew)
b. Pulling out the coffee pot (must return to warming plate within 30
seconds)
11. All other functions (PROGRAM, DELAY BREW, HOUR/MINUTES) are not
available during the brewing process.
12. Remove coffee pot to serve when finished brewing (about 1 minutes after
coffee stops dripping).
13. If all coffee will not be served immediately, the coffee can be kept warm on
the warming plate. The coffee maker will automatically shut off after 2 hours
from when the ON/OFF button was pressed, if it hasn't been manually turned
off.
14. Use caution while pouring coffee out of pot, as contents will be very hot!
15. Always turn off the coffee maker and disconnect the power supply when not
in use.
Note: The coffee that is brewed will be less than the water added, as some of the
water is absorbed by the coffee grounds. After brewing, allow 2-3 minutes to cool
in between brews.
WARNING: Do not allow children to use the 12 Cup Programmable Coffee Maker
unless there is adult supervision. The coffee maker dispenses very hot water!
Caution: Never leave an empty coffee pot on a hot warming plate, otherwise the
pot is liable to crack.

Helpful hints

•
If coffee tastes bad or weak, this may mean it is time for a cleaning
•
If coffee maker is not brewing right away, make sure you have allowed 2-3
minutes of cool down time in between cycles
•
Always use fresh, cold water in the coffee maker.
•
If coffee is ground too fine, it can cause leaking during brewing cycle
and/or cloudy looking coffee. If water is not coming out from the nozzle
during brew cycle, it may indicate excessive lime scale build-up, see
cleaning instructions for descaling.
User instructions
11