Features; Power Bar; Inserting And Removing A Bit; Dual Range Gear Selector - Urrea RB914 Manual De Usuario

battery pack may be short circuited causing
damage to the battery pack, burns or a fire. If
storing or disposing the battery pack, cover the
terminals with a heavy insulation tape to en-
sure short circuit cannot occur. Batteries, when
stored for a long period of time, will discharge.
• Do not store or use the tool and battery pack
in locations where the temperature may reach
or exceed 50°C such as alongside sheds or met-
al structures in the summer.
• Allow the battery pack to cool down after
charging. Do not place it in a hot environment
such as a metal shed or open trailer left in the
sun.
• Only charge the battery with the charger sup-
plied.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1
11
8
1. KEYLESS CHUCK
2. TORQUE SELECTOR
3. FUNCTION SELECTOR

4. DUAL RANGE GEAR SELECTOR

5. FORWARD/REVERSE CONTROL
6. LED WORK LIGHT
7. BATTERY PACK

8. POWER BAR

9. BATTERY PACK RELEASE BUTTON
10. VARIABLE SPEED TRIGGER SWITCH
11. CHARGER
CHARGER BATTERY PROCEDURE
3
4
2
5
10
9
6
7
E N G L I S H •
1. Attach the battery pack to
the charger by aligning the
raised portion of the bat-
tery pack with the slot in the
charger. Slide the battery
pack onto the charger.
2. The charger will communicate with the bat-
tery pack's circuitry to evaluate the condition
of the battery pack.
3. The POWER BAR LED lights will lit circularly
from right to left and the green LED indicator
will be flashing during charging. This is part of
the normal charging operation.
4. After charging is complete, the green LED on
the charger will come ON and the POWER BAR
LED lights will go OFF. The POWER BAR LED
lights will not be displayed when the POWER
BAR BUTTON is pressed while the battery pack
is on the charger.
5. The battery pack will fully charge, but will
not overcharge, if left on the charger.
NOTE: During the charging procedure, the bat-
tery warms up, this is normal.
POWER BAR
This Li-Ion battery pack is equipped with a
POWER BAR which is used to display the bat-
tery pack's remaining run time. Press the POW-
ER BAR button to display the LED lights.

INSERTING AND REMOVING A BIT

WARNING: Remove the battery pack and
set the forward/reverse control to the locked
center position when installing or removing
bits to prevent accidental starting.
TO INSTALL
Turn the keyless chuck
counter-clockwise direc-
tion to loosen the collet,
insert the bit or other ac-
cessory into the keyless
chuck and tighten secure-
ly by turning the keyless
chuck clockwise direction.
Make sure the keyless chuck is tightened in
place.
U se r's m a n ua l
80 - 100%
60 - 79%
40 - 59%
Charge
20 - 39%
> 10%
Completely
discharged
Tighten
Loosen
15