Checking The Delivery Contents; Installing The Appliance; Connecting The Appliance; Switching On The Appliance For The First Time - melitta BARISTA TS SMART Manual De Instrucciones

strips and the protective films from the
appliance.
Keep the packaging material for trans-
ƒ
port and any return shipments.
Information
The appliance may contain traces of coffee
and water. The appliance has been tested
in the factory to ensure that it functions
perfectly.
3.2 Checking the delivery
contents
Check the completeness of delivery using
the following list. If parts are missing,
contact your retailer.
ū Coffee spoon with screw-in aid for the
water filter
ū Plastic milk container or thermal milk
container each with milk hose or just
the milk hose (depending on the
model)
ū Stainless steel plate for cup tray
(depending on the model)
ū Coffee system cleaning agent
ū Milk system cleaning agent
ū Water filter
ū Test strip for determining the water
hardness.

3.3 Installing the appliance

Observe the following instructions:
ū Do not install the appliance in damp
rooms.
ū Install the appliance on a stable, flat
and dry surface.
ū Do not install the appliance in the vicin-
ity of sinks or the like.
ū Do not install the appliance on hot
surfaces.
ū Install the appliance at a sufficient
distance (approx. 10 cm) from the wall
and other objects. The space above the
appliance should be at least 20 cm.
ū Route the power cable so it cannot be
damaged by edges or hot surfaces.
3.4 Connecting the appliance
Observe the following instructions:
ū Check that the supply voltage matches
the operating voltage specified in the
technical data (see the , page 62
table).
ū Only connect the appliance to a prop-
erly installed earthing contact socket. If
in doubt, consult a specialist electrician.
ū The socket must have a fuse of at least
10 A.
3.5 Switching on the appliance
for the first time
During initial start-up, the language, the
time and the water hardness can be set.
The settings can be changed at a later
point in time (see chapter 8, page 53
and section 9.8, page 60).
Use the enclosed test strip to determine
the water hardness. Observe the instruc-
tions on the test strip packaging and in
the table Item, page 38.
Information
We recommend pouring away the first two
cups of coffee after initial start-up.
Requirement: The appliance has been
installed and connected.
1. Place a vessel beneath the outlet.
2. Press the ON/OFF button.
» The welcome display appears on the
appliance.
» The request to carry out the setup
appears on the display: Please set up
the machine.
» The "menu/ok" button flashes.
3. Confirm with "menu/ok".
» The Language menu appears.
4. Select your language with the arrow
buttons. Confirm with "menu/ok".
» The Clock menu appears.
5. Select the hour and the minutes with
the arrow buttons. Confirm each set-
ting with "menu/ok".
» The Water hardness menu appears.
First steps
41