Adjusting Top Thread Tension; Changing Presser Foot - Singer 7258 Manual De Instrucciones

ADJUSTING TOP THREAD TENSION

90% of your sewing will be done with the tension control dial (on
top of the machine) set at "AUTO" .
Helpful Hint: A slight adjustment to a higher number or a
lower number may improve sewing appearance.
STRAIGHT STITCHING
The correct appearance of your stitching is largely determined
by the balanced tension of both top and bobbin threads. The
tension is well balanced when these two threads 'lock' in the
middle of layers of the fabric you are sewing.
If, when you start to sew, you find that the stitching is irregular,
you will need to adjust the tension control.
Make any adjustments with presser foot 'down'.
A balanced tension (identical stitches both top and bottom) is
usually only desirable for straight stitch sewing.
ZIG ZAG and DECORATIVE SEWING
For zigzag sewing and decorative stitch functions, thread ten-
sion should be less than for straight stitch sewing.
You will always obtain a nicer stitch and less puckering when
the upper thread appears on the bottom side of your fabric.
BOBBIN TENSION
The bobbin tension has been correctly set at the factory,
so you do not need to adjust it.

CHANGING PRESSER FOOT

Be sure needle is in the up position. Raise presser foot lifter.
1. Push presser foot release lever to remove the foot.
2. Place the desired foot on the needle plate aligning the
presser foot pin with the foot holder.
3. Lower the presser foot lifter so that the foot holder snaps
on the foot.
28
Under side
Côté de dessous
Reverso
Well balanced
Correct
Bien equilibrada
Top side
Côté de dessus
Cara
Top stitch too tight
Fil supérieur trop tendu
Puntada superior
demasiado apretada
Decrease tension
Diminuer la tension
Disminuir tensión
Presser foot lifter
Levier de verrouillage du pied
Palanca pie prensatelas
1
Foot release lever
Levier de verrouillage du pied
Palanca de desprendimiento
2
prensatelas
Top stitch too loose
Fil supérieur trop lâche
Puntada superior
demasiado floja
Increase tension
Augmenter la tension
Aumentar tensión
3
Foot holder
Support du pied
Sujetador prensatelas