Chimney Assembly - Infiniton CMPT-CLR92S Manual Del Usuario

Hook the hood body
Hook the hood body to the bracket 20.

Level the hood body itself.

Remove the filter from the inside of the hood body, fix the screws 10 to Wall Plugs 11 at

the points (3).
Right
CONNECTIONS
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney
using either a flexible or rigid pipe ɸ 150 or ɸ 120 mm, the choice of
which is left to the installer.
If to install a ɸ 120 mm air exhaust connection, insert the reducer

flange 3 on the hood body outlet.
Fix the pipe 4 in position using sufficient pipe clamps (not supplied).

Remove possible charcoal filters.


CHIMNEY ASSEMBLY

The chimney can only be installed with exhausting hood.
Lower Decorative Chimney
Fix a Chimney fixing bracket 21 onto the Lower Decorative Chimney with 2 screws 12

(4.2x 9.5) supplied with the hood.
Upper Decorative Chimney
Insert the upper decorative chimney 2.2 into the lower decorative chimney 2.1 and drag it up

to the bracket 21.
Fix the upper chimney onto the bracket 21 with 2 screws 12 (4.2 x 9.5) supplied with the hood.

21
2.1
12
Wrong
EN-6