Type "B11" Appliance (See Data Plate); Cleaning And Maintenance; What To Do In The Event Of Breakdown; Procedure To Follow If The Appliance Is Not Going To Be Used For Some Time - Lotus BRF-94G Guia Para La Intalación E Instrucciones De Uso

Type "B11" appliance (see data plate)

1) Natural Discharge (fig.3)
Connection to a chimney with natural pull made reliably efficient by means of an anti-wind fitting and discharging the
products of combustion directly outside.
2) Forced Discharge (Fig.4)
The gas supply to the appliance must be directly interlocked to the system of forced discharge and must cut
off automatically in the event that its capacity goes below the values prescribed by item 4.3 by the UNI-CIG
norm 8723.
The relesase of gas to the appliance must be possible only manually.
In the event of installation, the end part of the discharge pipe of the appliance must be at least 1.8 m from the surface on
which the appliance is placed (ground). The section of the discharge pipe outlet must be placed inside the perimeter.
NATURAL DISCHARGE Fig.3
1) Anti-wind (blowback) chimney
Type "B11" appliances are supplied upon request with chimney or chimney and anti-wind (blowback) device to be
assembled and delivered separately.
Daily cleaning after switching off the appliance ensures the perfect functioning and long life of the appliance. The parts
in steel must be cleaned with a detergent-soaked cloth without rubbing; after that, rinse with clean water and dry with a
dry cloth. If the surface of the hotplate is not used for some time, it must be covered with a fine film of oil.

WHAT TO DO IN THE EVENT OF BREAKDOWN

Turn off the gas tap and notify the after sales service.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR
Turn off the gas tap, clean the installation as specified above.
GB IE

CLEANING AND MAINTENANCE

SOME TIME
33
FORCED DISCHARGE Fig.4
1) Extractor hood
2) Interlocking