Installation Of The Outdoor Unit; Connecting The Power Supply - Webasto Cool Top Trail 34 Instrucciones De Operación Y Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 111
400 x 400
Fig. 09: Sealant paths
Fig. 10: Forming an effective seal
4.7

Installation of the outdoor unit

Fig. 11: Position the outdoor unit
4.8

Connecting the power supply

Fig. 12: Location of the terminal block
Cool Top Trail 34
360 x 360
1
Turn the part over and on the reverse side of "This
X
side up", apply silicone sealant uniformly over the
path shown.
Turn the part over again and make sure "This side
X
up" is up. Press down firmly over the installation
hole and remove any sealant that has squeezed out.
Put the outdoor unit over the installed adaptor
X
frame and adjust the position to make sure the four
bolt holes on the corners align.
NOTE
The outdoor unit is heavy. Always have a
second person to help carrying the unit.
Do not lift the outdoor unit by the upper
white cover. Lift it by the bottom base.
Check with the M8 bolts if the holes of the
outdoor unit are aligned with the holes of
the adaptor. If not then reposition the out-
door unit to align the holes.
Do not apply additional sealant between
the outdoor unit and the adaptor frame.
Look upward from inside the vehicle, and locate the
X
terminal block (1).
Connect the power supply cable to the 3-pole termi-
X
nal block.
NOTE
Match the corresponding active, neutral
and the ground wire. Firmly tighten up the
screws to make sure the power line is not
loose or improperly connected, otherwise a
short circuit or fire could be caused.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido