Sleep Function; Units Of Temperature Change; Led Lights; Reset Of The Remote Control - Webasto Cool Top Trail 34 Instrucciones De Operación Y Instalación

5.13 Sleep function

SLEEP
Fig. 37: Setting the sleep function

5.14 Units of temperature change

°C/°F
Fig. 38: Celsius / Fahrenheit changeover

5.15 LED lights

NOTE
Function is only available for units with LED lights integrated into the air distributor.
Fig. 39: LED lights on the air distributor

5.16 Reset of the remote control

Fig. 40: Reset of the remote control
Cool Top Trail 34
The sleep function automatically modifies the target tempera-
ture value to provide a pleasant sleeping temperature. It also
helps to reduce compressor run time and thus energy con-
sumption as well as noise levels.
Press the
X
– The
up to indicate that the sleep function is activated.
– In COOL mode the set temperature will automatically
increase in two steps and it will have inceased by 2°C after
two hours.
– In HEAT mode the set temperature will automatically
decrease in three steps and it will have decreased by 3°C
after two hours.
– The sleep function is only available in COOL or HEAT
mode.
Press the
X
Press the
X
temperature display: Celsius or Fahrenheit.
– You can do this in any mode.
– The display on the air distributor follows the selection
°C/°F
made on the remote control.
Press the
X
tor which serve to illuminate the interior of the vehicle.
When LED lights are on you may press the
X
edly to adjust the brightness between 25% / 50% / 75% or
100%.
To turn off the lights, press
X
To reset the remote control to factory settings take out the
X
batteries and put them back in.
– The clock will have to be set again.
– The timer is deactivated.
key to activate the sleep function.
SLEEP
symbol in the display of the remote control shows
key again to deactivate the sleep function.
SLEEP
key to select the temperature units of the
°C/°F
key to turn on the LED lights on the air distribu-
LIGHT
key again.
LIGHT
key repeat-
DIM
18