Cueing; Memorizing A Sequence (Loop-Function); Relay-Operation - Omnitronic CDP-462 Manual Del Usuario

Delete a program:
In order to leave the program mode press the Program-button and hold it for approx. 3 seconds or open the
CD tray or switch the device off. As soon as you deleted the program, the Program-LED is off.

6.8. Cueing

Auto-Cue function:
After switching on or after pressing the Track-buttons, the player automatically jumps to the section where
the music starts. This fuction enable to minimize the transitions between two tracks.
Back-Cue function:
If you press the Cue-button during playback, the player returns the position where the playback started and
goes into Pause-mode. Please note that this function is only available within one track.
Memorizing the Cue-point:
Possibility 1:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Press the Play/Pause-button and the player goes into Playback-mode. The red Cue-LED shortly flashes
twice. The Cue-point was memorized at the position where you started the playback.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the Cue-point via the Jog/Shuttle-wheel. The display shows the selected starting-point (e.g. 3:42 22).
Press the Play/Pause-button and the player goes into Playback-mode. The red Cue-LED shortly flashes
twice. The Cue-point was memorized at the position where you started the playback.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.

6.9 Memorizing a sequence (Loop-function)

With the Loop-function, you can repeat a programmable sequence.
Memorizing the Loop-points:
Possibility 1:
The player is in Playback-mode.
If the loop-button is pressed in the playback-mode, the CD keeps running and the A-point (starting-point) is
marked (Loop-LED flashes). If the Loop-button is pressed once more, the B-point (end-point) of the
sequence is marked (Loop-LED shines permanently).
The player repeats the sequence between A-point and B-point until you press the Loop-button once more
(Loop-LED off).
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the A-point (starting-point) via the Jog/Shuttle-wheel. The display shows the selected A-point (e.g.
3:42 22). Press the Loop-button and the selected A-point is marked (Loop-LED flashes).
Select the B-point (end-point) via the Jog/Shuttle-wheel. The display shows the selected B-point (e.g. 3:51
11). Press the Loop-button and the selected B-point is marked (Loop-LED shines permanently).
The player repeats the sequence between A-point and B-point until you press the Loop-button once more
(Loop-LED off).

6.10 Relay-operation

In the Relay-operation, the device automatically switches to the other player after every track. In this way,
you have the possibility to enlarge the music program by using several CDs.
26/53
1060226N_V_1_0.DOC