Bosch GSB18V-535C Instrucciones De Funcionamiento Y Seguridad página 15

2610067378 05-21 GSB18V-535C.qxp_GSB18V-535C 5/19/21 1:37 PM Page 15
Adjustable Clutch
Your tool features 20 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 20. The drill "
will lock up the clutch to permit drilling and
driving heavy duty work, and also enables bits
to be changed quickly and easily in the keyless
chuck (Fig. 11).
ADjUSTABLE
FIG. 11
Brake
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
Built-in LED Work Light
Your tool is also equipped with an LED light that
turns on automatically when the switch is
activated, for better visibility when drilling/
driving (Fig. 1). The light turns off automatically a
short time after the trigger is released. You can
adjust this time frame using Bosch Tool Box app.
See "Connectivity" section.
Operating Instructions
" position
CLUTCH
SAVE THESE INSTRUCTIONS
Drill/Hammer Drill Selector Ring
(Model GSB18V-535C only)
The selector ring allows the tool to be set for
various drilling/hammer drilling applications.
Rotate the selector dial right or left depending
on the below applications (Fig. 12).
Drill only action: For drilling in woods, metals,
plastics or other non concrete materials.
MODE
SELECTOR
RING
Drill with hammer action: For drilling in
concrete, asphalt, tile or other similar hard
materials. The hammer drill position overrides
the clutch for drilling.
Temperature Overload
Protection
Avoid using battery operated tools continuously,
for long periods of time, while subjecting the
tool to overload conditions, such as drilling with
large diameter accessories into hard materials.
Using battery powered tools at extreme loads,
may cause the battery to exceed its allowable
operating temperature range. When the battery
exceeds normal operating temperature caused
by overload, the speed of the tool may be
reduced and the tool may appear to lose power.
To regain the tool's full performance, the battery
must be allowed to cool, until the operating
temperature returns to normal.
FIG. 12
15