Husqvarna Rider 213C Manual De Usuario página 15

Maintenance
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering wires
Examine the blades in the cutting deck
Clean the cutting deck, below the belt covers and below the cutting
deck
Make sure that the tire pressure is correct
Do a check of the parking brake
Change the engine oil
Change the oil filter
Clean the air filter
Change the air filter
Change the fuel filter
Do a check of the parallelism of the cutting deck
Lubricate the belt adjuster.
Examine and adjust the steering wires
Examine the muffler and heat deflector
Examine the cutting deck for damages
Change the spark plug
Adjust the parking brake.
Do a check of and adjust the throttle wire
Clean the cooling fins on the engine and the transmission
Clean the engine and the transmission
Do a check of the belts
Do a check of the battery
Do a check of the fuel hose. Replace it if necessary
Change the oil in the transmission
To clean the product
CAUTION: Do not use a high pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which cause damage to the
product.
Clean the product directly after use.
374 - 001 - 29.09.2017
Daily maintenance
before operation
X
X
X
*
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt from on and around
the transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use a high pressure.
Maintenance interval
in hours
25 50 100 200
X
X
X X
X
X X
X X
X
X
X
X X
X X
O O
O
O
O
O
O
O
O
O O
O
O
O O
15