Husqvarna Rider 213C Manual De Usuario página 27

• Empty the fuel tank. Start the engine and run it until
there is no remaining fuel in the carburetor.
Note: Do not empty the fuel tank and carburetor if a
stabilizer has been added.
• Remove the plugs and put about a tablespoon of
engine oil into each cylinder. Manually turn the
engine shaft to apply the oil and put the plugs back
on.
• Lubricate all grease nipples, joints and axles.
• Keep the product in a clean and dry area and cover
it for more protection.
• A cover for protection of your product during storage
or transport is available at your dealer.
Disposal
• Used engine oil, antifreeze etc. is dangerous and
must not be discarded on the ground or in nature.
Always discard used chemicals at a service center or
an applicable disposal location.
• When the product is worn out and no longer used,
send it back to the dealer or to an applicable
recycling location.
• Be careful with oil, oil filters, fuel and the battery,
because of the possible effects on the environment.
Obey the local recycling requirements and applicable
regulations.
• Do not discard the battery as domestic waste.
• Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
374 - 001 - 29.09.2017 27