M-system MFT 96 Serie Instrucciones De Uso página 257

9 - ELECTRICAL SECTION
IMPORTANT: The cooker must be
installed in accordance with the
manufacturer's instructions.
Incorrect installation, for which the
manufacturer accepts no responsi-
bility, may cause injury to persons
or animals etc.
GENERAL
– Connection to the mains must be car-
ried out by qualified personnel in
accordance with current regulations.
– The appliance must be connected to
the mains checking that the voltage
corresponds to the value given in the
rating plate and that the electrical
cable sections can withstand the load
specified on the plate.
– The plug must be connected to an
earthed socket in compliance with
safety standards.
– The appliance can be connected
directly to the mains placing an
omnipolar switch with minimum
opening between the contacts of 3
mm between the appliance and the
mains.
– The power supply cable must not
touch the hot parts and must be posi-
tioned so that it does not exceed
75°C at any point.
– Once the appliance has been
installed, the switch or socket must
always be accessible.
N.B. For connection to the mains, do
not use adapters, reducers or
branching devices as they can cause
overheating and burning.
If the installation requires alterations to
the domestic electrical system or if the
socket and appliance plug are incom-
patible, call an expert.
He should also check that the socket
cable section is suitable for the power
absorbed by the appliance.
Before effecting any intervention
on the electrical parts of the appli-
ance, the connection to the net-
work must be interrupted.
The connection of the appliance
to earth is mandatory.
The manufacturer declines all
responsability for any inconve-
nience resulting from the inobser-
vance of this condition.
257