Troubleshooting - Husqvarna R 214T Manual De Usuario

2. Remove the screws, one on each side, and remove
the transmission cover.
3. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
Max
4. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line. See
data on page 29 for recommended oil.
Troubleshooting schedule
If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
Problem
The starter motor does not turn
the engine over
26
Min
Technical

Troubleshooting

Cause
The parking brake is not applied. See
page 14 .
The lift lever for the cutting deck is in mow position. See
ting deck on page 13 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
page 9 .
The battery is too weak. See
The starter motor is defective.
To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
1. Remove the 2 screws that hold the belt shield and lift
it off.
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease is pushed out of the rear side of the nipple.
3. Attach the belt shield and tighten the 2 screws.
To apply and release the parking brake on
To replace the main fuse on page 19 .
To charge the battery on page 20 .
To lift and lower the cut-
Battery safety on
850 - 003 - 14.11.2018