Accessories - RIDGID R32102 Manual Del Operador

MAINTENANCE
Changing the Oil:
 Unplug the tool.
 Place the base of the saw on a horizontal surface.
 Remove the oil plug using a 6 mm hex wrench.
 Tip the saw up and let oil drain out into an appropriate
oil container.
 Replace the oil using a small funnel (less than 1/4 in.
spout). Take care to let air out while putting new oil in to
avoid spilling. Fill only with .5 oz. (15cc, or one tablespoon)
Mobil SHC 636 Oil.
 Fill the gear case until the oil level is between the two
marks on the dipstick. Do not overfill. If the level of oil
raises above the second mark on the dipstick while the
base is on a level surface, overheating may occur.
 Replace the oil plug with a 6 mm hex wrench. Do not
overtighten. The O-ring under the head should be com-
pressed slightly. Overtightening will cause the o-ring to
unseat and not seal properly.
NOTE: With a new saw, change the oil following the first
ten hours of use. This will prolong the life of the tool by
removing the gear particles from the oil when the gears
are breaking in.

ACCESSORIES

Look for these accessories where you purchased this product:
 Edge Guide ...................................................................................................................................................... 202050001
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 17 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
BRUSH REPLACEMENT
See Figure 26, page 19.
The tool has externally accessible brush assemblies that
should be periodically checked for wear.
 Unplug the tool.
 Remove the brush cap with a torx screwdriver. The brush
assembly is spring loaded and will pop out when you
remove the brush cap.
 Remove the brush assembly (brush and spring).
 Check for wear. If worn, always replace in pairs. Do not
replace one side without replacing the other.
15 - English