RIDGID R4222 Manual Del Operador página 22

Sierra ingleteadora
Ocultar thumbs Ver también para R4222:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
 If the top or bottom of the saw blade angles away from
the square as shown in figures 26 and 27, adjustments
are needed.
 Remove the bevel lock dust cover.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the bevel at any angle that allows access to the 4
screws on the back of the bevel lock bracket.
 Tighten the bevel lock knob.
 Using a 4 mm hex wrench, loosen the 4 screws that hold
the bevel detent plate in place. Do not remove the screws.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the saw at the 0º bevel angle, engage the bevel detent
lever and ensure the saw engages the detent.
 Check the 0° angle using a combination square.
 If adjustment is needed, use a 4 mm hex key to turn the
micro adjust screw on the front of the bevel lock bracket
to bring saw blade into alignment with the square.
 Tighten the bevel lock knob.
 Tighten the 2 outermost screws that retain the bevel
detent plate.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the bevel at 45°. Tighten the bevel lock knob.
 Tighten the remaining 2 screws that retain the bevel
detent plate.
 Replace the bevel lock dust cover and tighten the screws
securely. Recheck blade-to-table alignment.
Your saw has several scale indicators. After squaring
adjustments have been made, it may be necessary to loosen
the indicator screws and reset them to zero. See Figures
23 - 24.
SCREWS
BACK OF BEVEL LOCK BRACKET
SCREWS
FRONT OF BEVEL LOCK BRACKET
MICRO ADJUST
SCREW
22 - English
BEVEL DETENT
LEVER
BEVEL LOCK
DUST COVER
BEVEL
LOCK KNOB
Fig. 28
SCREWS
BEVEL DETENT
PLATE
Fig. 29

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

R4222t

Tabla de contenido