Intended Use; Technical Specifications - Torin T90203 Manual Del Propietário

IMPORTANT
Before You Begin Register This Product.
For future reference, record the model name, model number, date of manufacture and purchase date of this
product. You can find this information on the product.
Model Name ________________________
Model Number ________________________
Date of Manufacture ________________________
Date of Purchase ________________________
OWNER / USER RESPONSIBILITY
DO NOT OPERATE OR REPAIR THIS PRODUCT WITHOUT READING THIS MANUAL.
Read and follow the safety instructions. Keep Instructions readily available for operators. Make certain all
operators are properly trained and understand how to safely and correctly operate the product. By proceeding
you agree that you fully understand and comprehend the full contents of this manual. Failure to operate this
product as intended may cause injury or death. The manufacturer is not responsible for any damages or injury
caused by improper use or neglect. Allow product operation only with all parts in place and operating safely.
Use only genuine replacement parts. Service and maintain the product only with authorized or approved
replacement parts; negligence will make the product unsafe for use and will void the warranty. Carefully
inspect the product on a regular basis and perform all maintenance as required. Store these instructions
in a protected dry location. Keep all decals on the product clean and visible. Do not modify and/or use for
any application other than that for which this product was designed. If you have any questions relative to a
particular application, DO NOT use the product until you have first contacted the distributor or manufacturer to
determine if it can or should be performed on the product.
For technical questions please call 1-888-448-6746.

INTENDED USE

This Bottle Jack is designed for lifting. The jack can be used vertically or angled to 3 degrees from vertical
position. After lifting, loads must be immediately supported by jack stands. Each model is suitable for use in
lifting or positioning vehicles, machinery, houses and/or other building structures. These jacks comply with
ASME PASE Standards.

TECHNICAL SPECIFICATIONS

Item Capacity
T90203 2 TON
T90213 2 TON
T90403 4 TON
T90413 4 TON
T90603 6 TON
T90613 6 TON
T90803 8 TON
T91203 12 TON
T92003 20 TON
Lifting Range Lifting Range
Min. (inch) Max. (inch)
7-1/8
7-1/8
7-5/8
7-5/8
8-1/2
8-1/2
9-1/8
9-1/8
9-1/2
2
Lifting Range
Min. (cm)
13-5/8 18.1
13-9/16
14-5/8 19.5
14-3/4 19.4
16-1/4 21.6
16-5/16 21.6
18
18-1/4
17-3/4
Lifting Range
Max. (cm)
34.5
18 34.4
37
37.2
41.3
41.3
23 45
23 46.5
24 45