Troubleshooting - SmartLife SL-WMTL60M Manual De Instrucciones

Ocultar thumbs Ver también para SL-WMTL60M:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

The start of the appliance does not work or it stops during operation.
First try to find a solution to the problem, If not, contact the service centre.
PROBLEM
INSPECTION ITEMS
If the power is off or the fuse is burned out.
No water
If the water supply is cut off or the water pressure is too low.
flows in
If the inlet hose is properly connected and the water tap is
opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched
on)
If the "Start / Pause" button is pressed after the power switch
is pressed.
If the power is off or the fuse is burned out.
No washing
If the power supply voltage is too low.
If the water amount reaches to the required water level.(The
washer will not work if the water amount does not reach the
required water level). If it is set to "Delay" washing mode. (It
will only start to work until the reservation time reached).
If the water drain hose is placed very high.
Abnormal
If the end of water drain hose is sealed in pond.
draining
If the internal rubber ring of drain valve is blocked by dirt.
If the door lid is closed.
Abnormal
If all clothing piled largely at one side of barrel or the clothing
spin
is excessively placed.
If the washer is not placed in stable condition or it is placed
in inclination state. (The ground is not flat).
If the motor belt is loosened.
31
DESCRIPTION
PROBLEM
Alarm for abnormal water intaking.
E1
Alarm for lid not closed before wash
E2
and spin.
Alarm for washing stay at one side. Manually balance clothes in the
E3
Alarm for water drain has not
E4
finished.
Others
EEX
After the check, activate the appliance. If the problem occurs or the display shows other
alarm codes again, contact the service.
SOLUTION
Check the water tap is opened or
not.
Closed the lid.
barrel by hands.
Check the water level sensor and
drain pump.
Please try again first, call up service
line if there are still troubles
32

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido