BASKET
If your unit came with a basket, insert basket through center of carriage handle and slide
into place. The basket does not come standard with all models.
SIDE TANK HANDLES
If your unit came with side tank handles, attach handles to tank with screws provided.
TOOL HOLDER
(Not standard with all models)
If your unit came with a tool holder, assemble as follows:
1. Set tank cover onto the tank. Position with back of tank cover facing
you.
2. Take tool holder and place tabs on tool holder into slots on back of
tank cover.
3. Press down until tabs snap into place. Remove tank cover from tank and refer to the
set up and operation section.
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters
are installed for your cleaning operation.
2. Replace tank cover. Make sure each latch or clamp is secured over the raised area
of the tank cover. Failure to properly secure the latches could cause the tank cover to
release from the tank.
3. Install machine hose end into inlet located on the front of the tank.
4. Attach the desired cleaning accessory onto the accessory end of the hose. NOTE: Many
more useful tools are available at your local dealer or the Shop-Vac
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
ASSEMBLY (CONT'D)
SET UP AND OPERATION
–
This equipment incorporates parts such as switches, motors or the
website.
®
PAGE 9