Setup; Setup Location Requirements; Feet - CASO DESIGN DryAged Master 63 Manual De Instrucciones

14.5 Setup

14.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• Place your device on a floor that is strong enough to support the device when it is fully
loaded.
• Locate the device away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
• This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near
•
flammable material.
• The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the device.
• WARNING! Do not close the ventilation openings in the device housing.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
• For energy saving reasons please ensure that the door is closed when the device is
turned on.
14.5.2

Feet

There are different feet (3 bigger feet and 1 small foot).
To level your device, adjust the small foot at the bottom of the device.
37