Replace Injector On (Oven Grill Burner)
1) Remove the door as described in the paragraph "Door removal";
2) The range is equipped with two broiler burners. Remove the screws A securing the broiler burners and withdraw the
burners from the support.
3) Remove the injector by turning 9-32" nut driver counter clockwise;
4) Install the injectors supplied with this appliances in the appropriate burner. The injectors have small number stamped on
the side, this number codes the orifice diameter and its correct burner location (see figure of the paragraph "Injectors
position").
5) Turn clockwise to tighten (tighten to a torque of 15 to 20 inch-lbs).
6) Replace all parts following the reverse order paying attention to the correct placement of the burner.
7) Save the injectors removed from the appliances for future use.
Proceed to Pressure Regulator Conversion noting the LP / Propane position to complete the conversion. After replacing the
injectors adjust the burner flame (see Low Flame Adjustment paragraph).
Check the appearance of each burner's flame at HILO settings, if the flame appears too large or too small make sure that all
steps were completed correctly.
29
EN