Troubleshooting
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug
from electrical outlet before performing maintenance or troubleshooting checks.
Problem
AUTOMATED CLEANING
SpotBot will
not run
Unusual or
odd noise
Reduced or
no spray
No suction
MANUAL CLEANING
Cleaner will
not run
Unusual or
odd noise
Reduced or
no spray
No suction
14
www.BISSELL.com
Possible causes
Power cord not plugged in
Blown fuse/tripped breaker
Vacuum flex hose is not snapped
into place securely
Clean water/solution tank is
out of fluid
Clean water/solution tank is out
of fluid
Clean water/solution tank is not
inserted into the unit securely
Tank is full
Dirty water/collection tank latch
is not down
Black valve on the dirty
water/collection tank is missing
Power cord not plugged in
Blown fuse/tripped breaker
Hose not removed from receiver
SpotBot shut off automatically
during use
Clean water/solution tank is
out of fluid
Spray tip clogged on Tough Stain
brush
Clean water/solution tank is out
of fluid
Clean water/solution tank is not
inserted into the unit securely
Tank is full
Dirty water/collection tank latch is
not down
Black valve on the dirty
water/collection tank is missing
Remedies
Check electrical plug
Replace household fuse or reset
breaker
Check to make sure the vacuum flex
hose is snapped into place
Fill clean water/solution tank
Fill clean water/solution tank
Gently press the clean water/solution
tank until you see "bubbles" coming
from the base of the tank
Empty tank
Push latch down, securely into place
Replace black valve into dirty
water/collection tank
Check electrical plug
Replace household fuse or reset
breaker
Remove hose
Press Pause/Resume button to
resume manual cleaning
Fill clean water/solution tank
Clean spray tip
Fill clean water/solution tank
Gently press the clean water/solution
tank until you see "bubbles" coming
from the base of the tank
Empty tank
Push latch down, securely into place
Replace black valve into dirty
water/collection tank