Assembly/Pre-Operation - Craftsman 917.27394 Manual Del Usuario

(1) Small
Retainer Springs
(5) Large
Retainer Springs
If Equipped
(1) Anti-Sway Bar
(1) Small Retainer
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(2) 7/16" wrenches
(1) 1/2" wrench
(1) 3/4" wrench
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench
When right or left hand is mentioned in this
manual, it means when you are in the operating
position (seated behind the steering wheel).
UNASSEMBLED PARTS
Mower
(2) Rear
Lift Link
Assemblies
(1) Front
Lift Link
Assembly
(1) 3/4 O.D.
Washers
Springs

ASSEMBLY/PRE-OPERATION

Utility knife
Tire pressure gauge
Pliers
Flashlight
Mower Front Wheel
(1) Shoulder Bolt
(1) Wheel
(1) Oil Drain Tube
Keys
(2) Keys
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts cartons from carton.
• Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
• Check for any additional loose parts or
cartons and remove.
7
(1) 1-1/4 O.D.
Washer
(1) 3/8-16
Locknut
Quick Connect
Slope Sheet