Features; Assembly; Operation - RIDGID JobMax R8223412 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
No Load Speed ........................0-3000 strokes per minute

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Cutting all types of wood products (lumber, plywood,
paneling, composition board, and hard wood), cutting
masonite, plastic and drywall; cutting metals such as
sheet steel, pipe, steel rods, aluminum, brass, and copper
(metal cutting blade sold separately)
Stroke Length ........................................................... 1/2 in.
WARNING:
Do not attempt to modify this product or create
attachments or accessories not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
INSTALLING AND REMOVING THE
RECIPROCATING SAW HEAD
See Figure 1, page 7.
To install the reciprocating saw head:
 Remove the battery pack from the power base or
disconnect the power base from the power supply.
Place the head on the power base and push until the

latches click into position. Pull on the head to make sure
it is securely installed before proceeding.
 Reinstall the battery pack or connect the power base to
the power supply.
To remove the reciprocating saw head:
Remove the battery pack from the power base or

disconnect the power base from the power supply.
Depress the latches on the power base and pull the

reciprocating saw head away from the power base.
SELECTING BLADES
Selecting the correct type of blade is important in order to
obtain the best performance from the saw. Select the blade
based on the application and on the material you wish to
cut. Selecting the right blade will give you a smoother, faster
cut and prolong the life of the blade.
Blades with fewer teeth, 10 teeth per inch (TPI) are typically
used for cutting wood, while blades with more teeth are
better for cutting metal or plastic. We recommend 14 TPI for
plastics and soft metals and 18 TPI for hard metals.
4 - English