Glossary Of Terms; Special Terms - RIDGID MobilAir TRI-Stack OF50150TS Manual Del Operador

GLOSSARY OF TERMS

Air Filter
Porous element contained within a metal or plastic housing
attached to the compressor cylinder head which removes
impurities from the intake air of the compressor.
Air Tank
Cylindrical component which contains the compressed air.
Amperage Overload Switch (Manual)
Automatically shuts off the compressor if the temperature of
the electric motor exceeds a predetermined limit.
Check Valve
Device that prevents compressed air from flowing back from
the air tank to the compressor pump.
Cut-In Pressure
The low pressure at which the motor will automatically
restart.
Cut-Off Pressure
The high pressure at which the motor will automatically
shut off.
Electric Motor
Device which provides the rotational force necessary to
operate the compressor pump.
On/Off Switch
Control which turns the air compressor on or off. The
pressure switch will not automatically start and control the
compressor unless the manual On/Off Switch is in the ON( l )
position.
NPT (National Pipe Thread)
A seal thread tape must be used to provide a leak-free seal
on pipe threaded connections.

SPECIAL TERMS

Quarter turn drain valves:
Quarter turn drain valves are located on tanks for easy
draining of condensation to help prevent tank corrosion.
Compressor tank:
The air compressor and 0.5 gallon tank.
Main tank:
The 4.5 gallon tank.
Unregulated air hose:
This hose transmits the compressed air from the compressor
tank to the main tank.
Unregulated air quarter turn ball valve lever:
This valve opens to allow compressed air to flow from the
compressor tank to the main tank and closes to stop air flow
form the compressor tank to the main tank.
Pressure Regulator Knob
Regulates the outgoing pressure from the air outlet to the
tool. It is possible to increase or decrease the pressure at
the outlet by adjusting this control knob.
Pressure Switch
Automatically controls the on/off cycling of the compressor.
It stops the compressor when the cut-off pressure in the tank
is reached and starts the compressor when the air pressure
drops below the cut-in pressure.
PSI (Pounds Per Square Inch)
Measurement of the pressure exerted by the force of the
air. The actual psi is measured by a pressure gauge on the
compressor.
Pump
Produces the compressed air with a reciprocating piston
contained within the cylinder.
Regulator Pressure Gauge
Displays the current line pressure. Line pressure is adjusted
by rotating the pressure regulator knob.
Safety valve
Prevents air pressure in the air tank from rising over a
predetermined limit.
SCFM (Standard Cubic Feet Per Minute) or CFM (Cubic
Feet Per Minute)
A unit of measure of air delivery.
Tank Pressure Gauge
Indicates the pressure in the air tank.
Unregulated air intake coupler:
This coupler is an air inlet only for the unregulated air hose
and is located on the main tank.
Unregulated air fitting:
This 1/4 in. NPT quick-connect fitting connects the
unregulated air hose and is located on the main tank.
Lock/release knob:
Detaches and reattaches compressor tank and main tank.
Docking plate:
This plate supports the compressor tank when it is seated
on top of the main tank.
8 – English