Adjusting The Footrest; Optional Angle Adjustable Footplate - Ki Mobility TSUNAMI AL Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
P. Adjusting the Footrest
Height Adjustment of Footrest:
1. On each side of the frame, the footrest tube is
held in place by a flat (versus rounded) M6
socket head screw. Loosen the screw by using
an M4 Allen wrench. Do the same for both
sides.
2. Once the bolt is loosened, you may adjust the
footrest extension tube up or down to the
desired height within the side frame.
3. Ensure that both sides are adjusted equally.
4. Retighten to 40 in/lbs.
Q. Optional Angle Adjustable Footplate
To adjust the angle of the optional angle adjustable footplates:
1. Loosen, but do not remove, the two M6 screws securing the footplate to the footplate clamp
with a 4mm Allen wrench.
2. Once loose, the footplate will easily rotate around the footrest extension tube.
3. Select the desired position and retighten the two M6 screws to 80 in/lbs.
To change the position of the optional angle adjustable footplates:
1. Remove both M6 screws from the footplate. There are M6 nylock nuts recessed on the
underside of the clamp. Be sure to prevent these from falling as you loosen the screws.
2. Relocate the footplate and insert the screws into the appropriate holes.
3. Fit the nuts into the slot underneath the clamp and tighten the screws.
Fig. 22
30
Fig. 21