Arregui IGNUM 41050 Manual De Instrucciones Y Garantías página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
FIREPROOF SAFE –IGNUM 41050 -41060
For improved Security your Fireproof Safe has provision to be anchored
a Concrete floor using the Mounting Bolt Included.
Concrete Floor
a.Anchoring Pipe
b.Setting Tool
1. Mark Mounting Location.
2. Using a Hammer Drill – Drill a 10mm diameter hole to a depth of
30mm using a Masonry Drill Bit.
3. Remove the white stickers & Insulation material located on the Floor
inside the Safe & the bottom of the outside of the Safe.
4. Remove the Rubber Feet.
5. Insert the Anchoring Tube (a) into the drilled hole, Place the setting
tool (b) into the opening of the Anchoring Tube. Using a Hammer
tap the setting tool until the stepped section touches the top of the
Anchoring Tube.
6. Position Safe for Fixing to the Anchor on the Floor.
7. Insert Anchoring Bolt (c) into the hole in the floor of the Safe.
8. Position the 2 Washers (d & e) between the bottom of the Safe & the
floor. The Flat Washer (d) needs to be on top of the Spring Washer (e).
9. Screw in Anchoring Bolt (c).
10. Cover the hole inside the Safe using the Anchoring Hole Cover (f ).
IMPORTANT:
Please ensure the Safe is operating correctly BEFORE Mounting.
MOUNTING INSTRUCTIONS
f
c
d
e
a
ø10
30mm
1
c.Anchoring Bolt
b
a. Anchoring Pipe
b. Setting Tool
c. Anchoring Bolt
d. Flat Washer
e. Spring Washer
f. Anchoring Hole Cover
d.Flat Washer
e.Spring Washer
<EN>
a
2
f. Anchoring Hole Cover

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ignum 41060

Tabla de contenido