°C
Connect the power unit to wall outlet, the LED indicator will start to blink on the display.
Now it is possible to switch on the infrared heaters, the light and the music function.
Startup
Press
to switch on the display and heaters, the length of time is automatically set to 99 minutes and the air temperature inside
the cabin will be displayed. Press
Temperature settings
The left display refers to the air temperature. Press
or
, 1 push= 1°C.
The setting number blinks 10 seconds then automatically presents the air temperature.
Arrived at the desired temperature, the heaters will stop working automatically.
When it fall 2°C below the desired temperature, the cabin will restarted automatically.
Note:
The maximum air temperature reachable in the cabin may be lower than the desired temperature. This is dependent on the
temperature outside the cabin. Default temperature = 40°C
Time settings
The right display refers to the length of time. Press
or
, 1 push = 1 minute.
The setting number blinks 10 seconds then automatically presents the air temperature.
When countdown to 00, the heaters will shut off automatically.
Default time = 99 minutes.
Color light
Short press
, you can set the desired color (7 color totally) and turn off the light.
Long press
to go into an automatically cycling mode, changing 7 colors every 5 seconds.
MP3 player
Long press
to switch ON/OFF the MP3 player. You can select the mode by short pressing the
CARD (if have) --- Bluetooth --- FM radio -- LINE (empty).
USB/SD or Bluetooth mode: You can select songs by short pressing the
pressing the
or
FM radio mode: Long press
select station by short pressing the
Infrawave technology
The button is on each panels and permit to choose the technology used:
Push
to the 2 lines side for use on the panel quartz technology.
Push
to the circle (middle) for turn off the panel.
Push
to the 1 line side for use on the panel only magnesium technology.
12
Using the sauna
min
again switch off the heaters.
. The
key for pause.
to search stations (87.5 MHz - 108 MHz) automatically, the system will save all of them. You can
or
and adjust the volume (0 - 32) by long pressing the
ON / OFF
Temperature setting
Time / Temperature
, you can set the desired temperature from 35°C to 60°C by pressing the
, you can set the desired time from 5 minutes to 90 minutes by pressing the
or
Color light
Time setting
+
Time / Temperature
button : USB or MMC
and adjust the volume (0 - 32) by long
or
.
-