Publicidad
TIGHTENING A NUT
1 Start the nut by hand, ensuring it is not cross threaded, then with the appropriate socket installed on the wrench,
place it on the nut.
2. With the FORWARD/NEUTRAL/REVERSE switch in the FORWARD position, and holding the wrench firmly in BOTH
HANDS, pull the trigger gently. You can vary the spindle speed by modulating finger pressure on the trigger.
3. Run each nut up in turn until it is 'nipped' up only - do not tighten - do not fully depress the trigger. When all nuts
are nipped up, tighten progressively by pulling the trigger fully and allowing the action to operate for 3 to 4 impacts only to
prevent overtightening.
4. ALWAYS finish tightening with a torque wrench or suitable spanner. The weight of the vehicle will need to be placed
on the wheel to prevent it from rotating while the nuts are tightened. Ensure the final torque applied to the nuts meets the
vehicle manufacturers recommendations.
7. MAINTENANCE
CLEANING
• Always inspect the tool before use, and ensure it is in top condition.
• Ensure all air vents are clear, (use compressed air to clean the machine if possible).
GENERAL MAINTENANCE
• Ensure all nuts, bolts and screws remain tight to ensure the machine is in safe working condition.
• Refer to your RAIDER dealer if internal maintenance is required.
• Check the power cable to ensure it is sound and free from cracks, bare wires etc. avoid using solvents when cleaning
plastic parts, most plastics are susceptible to damage from the various types of commercial solvents.
• All bearings etc, in this tool are lubricated with a sufficient amount of high grade lubricant for the tools lifetime under
normal operating conditions, therefore no further lubrication is required.
8. REPLACING THE CARBON BRUSHES
To change graphite brushes, visit Ryder's authorized service center.
9. STORAGE
1. Make sure that the tool is stored in a clean, dry place, out of reach of children when not in use.
2. Always store the impact wrench and its sockets in the case supplied.
10.
Disposal.
The machine, accessories and packaging should be sorted for environmental-friendly recycling. The plastic components
are labelled for categorized recycling. Do not dispose of power tools into household waste! According the European
Guideline 2012/19/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools
that are no longer usable must be collected separately and disposed of in an environmentally correct manner.
11
Publicidad
