Functional Description; Loading Staples - Makita BST221 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
009148
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while sliding the button on the front of the
cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Safety system
1
009151
Make sure all safety systems are in working order before
operation. The tool must not operate if only the switch
trigger is pulled or if only the safety lever is pressed
against the wood. It must work only when both actions
are performed. Test for possible faulty operation with a
tool unloaded and pointed well away from yourself or any
bystanders.
1. Red part
2. Button
3. Battery cartridge
3
1. Trigger
2. Safety lever
2
NOTE:
There is a possibility that the tool may operate for
•
an instant when only the trigger is pulled. This does
not indicate a problem. If this occurs, point the tool
well away from yourself or any bystanders. Release
and pull the trigger again to make sure the safety
systems are in working order.
ASSEMBLY
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger and the battery cartridge is removed
before carrying out any work on the stapler.
Staples
Handle the staples and their box carefully. If the
•
staples have been handled roughly, they may be
bent out of shape, causing poor staple feed or
jamming.
Avoid storing the staples in a very humid or hot
•
place or place exposed to direct sunlight.
CAUTION:
Do not use staples other than designated in this
•
manual or staples that appear to be damaged, bent,
rusty or corroded.
Do not insert staples of which size is different each
•
other at the same time inside the magazine ,
causing poor staple feed or jamming.

Loading staples

Remove the battery cartridge.
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
009152
Load staples into the main magazine with their feet
facing up. Slide the sub-magazine forward.
5
1. Sub magazine
1
2. Locking lever
2