RIDGID R4513 Manual Del Operador página 17

ASSEMBLY
MOUNTING HOLES
The table saw must be mounted to a firm supporting surface
such as a workbench or leg stand. Four bolt holes have been
provided in the saw's base for this purpose. Each of the
four mounting holes should be bolted securely using 1/4 in.
carriage bolts, washers, lock washers, and wing nuts. Bolts
should be of sufficient length to accommodate the saw base,
washers, lock washers, wing nuts, and the thickness of the
workbench. Tighten all four bolts securely.
Carefully check the workbench after mounting to make
sure that no movement can occur during use. If any tipping,
sliding, or walking is noted, secure the workbench to the
floor before operating.
MOUNTING THE LEG STAND ON THE TABLE
SAW BASE
See Figures 12 and 13.
WARNING:
Do not lift the saw without help. The saw weighs
approximately 80 lbs. Hold it close to your body.
Keep your knees bent and lift with your legs, not
your back. Ignoring these precautions can result
in back injury.
 Open leg stand as described on page 23.
 Place saw base on the leg stand. Align the holes in the
table with the holes in the end braces.
 Insert a bolt through the hole in the table saw and into
the hole in the stand. Hand tighten using hex nut.
 For the remaining holes, insert the bolts through the hole
in the saw base and into the hole in the stand, then secure
to the stand using a hex nut.
 Tighten all hardware with a wrench and hex key. You may
find it helpful to use a wrench to hold the head of the bolt
and the hex key to tighten the hex nut.
 Move the leg set to desired location. Adjust the leveling
foot by turning wing nuts.
BOLT
WING
NUT
Fig. 12
17 − English
SAW BASE
HEX NUT
Fig. 13