Toolland WHW420 Manual Del Usuario página 6

Safety Instructions for Servicing
Wear safety goggles and heavy-duty leather gloves during maintenance.
When replacing a line, do not use a thinner or longer line than recommended by the manufacturer. Do not link
multiple lines together.
Have the device repaired by a qualified service person using only identical replacement parts. This ensures that
the safety of the device is maintained.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
 Familiarise yourself with the functions of the device before actually using it.
 All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
 Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Keep this manual for future reference.
4. Features
 solid gear construction
 black electrostatic discharge coating finish against rusting
 internally lubricated drum and pinion gear bushings
 moulded handle for smooth rotation
 formed reinforcements in frame for added strength.
5. Overview
Refer to the illustrations on page 2 of this manual.
frame
1
pawl
2
shaft
3
Pawl Positions
The pawl has three positions:
reeling in: turn the handle clockwise to reel in the line.
a
free spooling: turn the handle in any direction to reel in or out.
b
reeling out: turn the handle counter-clockwise to reel out the line.
c
Warning! If a load is attached to the line, keep a firm grip on the handle when switching the pawl position or
when using free spooling.
6. Installation
Read the entire safety instructions at the beginning of this manual before installing the device.
1. Choose a suitable mounting location. Take care of the following points:
The mounting structure and hardware must be able to support the winch and the load without damage
o
or weakening. If necessary, use steel reinforcement plates or additional bracing.
Make sure that the handle [5] can rotate freely by 360°.
o
2. Place the winch on the mounting surface [6] and mark the location of the mounting holes.
3. Before drilling, verify that there are no hidden parts or structural pieces in the mounting area that can be
damaged.
4. Drill the holes at the marked locations.
5. Use three 3/8" (M10) bolts, washers, and lock nuts (not incl.) to fix the winch frame [1] on the mounting
surface [6].
V. 02 – 09/02/2017
WHW420
drum
4
handle
5
mounting surface
6
6 ©Velleman nv