Maxon 295990-01G Instrucciones De Instalación página 22

INSTALLING CAMERA AND SENSORS (IF EQUIPPED) - Continued
3. Adjust camera angle by loosening
1/4" hex bolt and lock nut. Then rotate
camera mounting bracket to correct
angle as shown in FIG. 22-1. Tighten
hex bolt and lock nut when desired
camera angle is set.
4. Install each of the OEM sensors (if
equipped) into 4 brackets as shown
in FIGS. 22-2 & 22-2A.
5. Use plastic ties (Kit item) to secure
sensors to mounting brackets as
shown in FIG. 22-2A.
6. Connect OEM sensor harness on
the vehicle to all sensors.
LIFT CORPORATION Sht. 22 of 54 DSG#
OEM SENSOR
(4 PLACES)
SENSOR MOUNTING
BRACKET
(4 PLACES)
CAMERA MOUNTING
BRACKET AND OEM
CAMERA
60° MAXIMUM
TILT
ADJUSTING CAMERA ANGLE
SENSOR MOUNTING
BRACKET
OEM SENSOR
INSTALLING SENSORS (IF EQUIPPED)
FIG. 22-2
M-15-10
Rev. D Date: 09/21/18
LOCK NUT 1/4"-20
CAMERA BASE
FIG. 22-1
FIG. 22-2A
BRACKET
PLASTIC
TIE