Angle Adjustment - Palmgren 11602A Manual De Operación Y Lista De Partes

Palmgren Operating Manual & Parts List
OPERATION
Refer to Figure 2.
• Mount vise to work surface in desired
location by securing both mounting
flanges located on swivewl base (Ref. No.
24).
• Rotate vise to desired position. A scale
and indicator are provided for reference.
Tighten hex nuts (Ref. No. 20) to secure
base (Ref. No. 1) to swivel base (Ref. No.
24).
• Open jaws of vise and place workpiece
between jaws in desired position.
Secure workpiece between jaws by
rotating leadscrew with handle. (Ref.
No. 19). Be sure workpiece is held
securely in vise before starting machin-
ing operation.

ANGLE ADJUSTMENT

• Loosen four bolts (Ref. No. 5).
• Loosen nut (Ref. No. 9).
• Use "0" mark on the body to set vise at
desired degrees from horizontal.
• Tighten four bolts and nut to lock
angle position.
MAINTENANCE
Particles of metal or wood can damage
machined surfaces, causing difficult or
inaccurate operation.
• The vise is shipped with a protective
coating. This coating should be
removed before operation. Use pene-
trating oil to remove protective coating.
• Keep machined surfaces and all mov-
ing parts clean and free of dirt, chips
and foreign materials.
• Keep machined surfaces lubricated
with medium weight machine oil.
3
11602A