Automatic Timer; The Timer; Cleaning Lock; Automatic Time Limitation - NEFF N4.D30 Serie Instrucciones De Uso

Once the time has elapsed
The hotplate switches off. A warning signal sounds.
on the hotplate and appears for 10 seconds on the time
‹‹
program function display. The
Pressing the symbol turns off the indicators and stops the
3
beep.
Changing or cancelling the time
Select the hotplate and press the
Change the cooking time using the + or - symbols, or set to
‹‹ .
Notes
Select a hotplate to check the remaining cooking time.
■
Any cooking time can be programmed for up to 99 minutes.
■

Automatic timer

With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time can be changed or cancelled for any
hotplate:

Cleaning lock

Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the " symbol. A beep sounds. The control panel is
locked for approximately 35 seconds. The surface of the
control panel can now be cleaned without risk of changing the
settings.
Note: The lock does not affect the
The hob may be switched off when desired.

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
appears
‹
indicator flashes.
x
symbol.
3
" symbol or the main switch.
" and
Select the hotplate: Press the symbol
lights up. Change the cooking time using the + or - symbols, or
set to ‹‹ .

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
Press the symbol
1.
appears on the time program function display.
Press the + or - symbol. The basic setting appears.
2.
+ symbol: 10 minutes.
- symbol: 5 minutes.
Set the required time using the + or - symbol.
3.
After a few seconds, the timer will start to count down.
Once the time has elapsed
A warning signal sounds.
function display and the
Press the symbol. After 10 seconds the indicators go out
3
and the beep stops.
Changing or cancelling the time
Press the symbol
time with the + or - symbols, or set to
‰
3 until the indicator
3 until the indicator S
‹‹ appears on the time program
S indicator flashes.
3 until the indicator S lights up. Change the
.
‹‹
x
lights up. ‹‹
23